|
Below is the stab file located in var/state/pcmcia: Socket 0: empty Socket 1: Xircom CardBus 10/100 Ethernet + 56K Modem 1 network tulip_cb 0 eth0 1 serial serial_cb 0 ttyS1 4 65 Below is the system log: Feb 10 09:53:11 localhost syslog: syslogd startup succeeded Feb 10 09:53:11 localhost syslog: klogd startup succeeded Feb 10 09:53:12 localhost atd: atd startup succeeded Feb 10 09:53:12 localhost crond: crond startup succeeded Feb 10 09:53:13 localhost pcmcia: Starting PCMCIA services: Feb 10 09:53:13 localhost pcmcia: modules Feb 10 09:53:13 localhost pcmcia: cardmgr. Feb 10 09:53:13 localhost rc: Starting pcmcia succeeded Feb 10 09:53:13 localhost inet: inetd startup succeeded Feb 10 09:53:14 localhost lpd: lpd startup succeeded Feb 10 09:53:14 localhost keytable: Loading keymap: Feb 10 09:53:14 localhost keytable: Loading /usr/lib/kbd/keymaps/i386/qwerty/us.kmap.gz Feb 10 09:53:15 localhost keytable: Loading system font: Feb 10 09:53:15 localhost rc: Starting keytable succeeded Feb 10 09:53:16 localhost sendmail: sendmail startup succeeded Feb 10 09:53:17 localhost gpm: gpm startup succeeded Feb 10 09:53:17 localhost xfs: xfs startup succeeded Feb 10 09:53:18 localhost linuxconf: Linuxconf final setup Feb 10 09:53:21 localhost rc: Starting linuxconf succeeded Below is the output of cardctl config: Socket 0: not configured Socket 1: Vcc 3.3V Vpp1 3.3V Vpp2 3.3V interface type is "cardbus" irq 3 [exclusive] [level] function 0: io 0x0a00-0x0a87 [32bit] function 1: io 0x0a00-0x0a87 [32bit] And finally, below is the output of setserial -a /dev/ttyS1: /dev/ttyS1, Line 1, UART: 16550A, Port: 0x0a80, IRQ: 3 Baud_base: 115200, close_delay: 50, divisor: 0 closing_wait: 3000, closing_wait2: infinte Flags: spd_normal skip_testlink David, Please let me know if there is anything else you need. By the way, after reading Albert's post above, I am thinking that my problem may be similar. I am in the process of compiling 3.1.10 right now. Thanks again for any help you may be able to provide. |